Download presentation
Presentation is loading. Please wait.
Published byElmer Stephens Modified 6년 전
1
Hydroforming 하이드로포밍의 적용 유형 : 튜브 vs. 판재 튜브 벤딩 금형 구조 하이드로포밍 제품
프레스 설비 및 생산라인
2
하이드로포밍의 적용(1) Drive shaft Inlet cone BMW rear axle
3
하이드로포밍의 적용(2)
4
Tube vs. Sheet Hydroforming
5
Production line for tube hydroforming
6
Tube bending(1)
7
Tube bending(2)
8
Tube bending(3)
9
하이드로포밍의 해석(1)
10
하이드로포밍의 해석(2)
11
하이드로포밍의 해석(3)
12
Schematic view of a die layout
금형 구조(1) Schematic view of a die layout
13
Die systems for prototyping and production
금형 구조(2) Die systems for prototyping and production
14
금형 구조(3) Hole punching, notching and bending during hydroforming
15
Internal pressure as a function of the inside radius
하이드로포밍 범위(1) Internal pressure as a function of the inside radius
16
Hydroforming parts for the fitting industry
하이드로포밍 범위(2) Hydroforming parts for the fitting industry
17
Present state of the art in hydroforming using tubes as blanks
하이드로포밍 범위(3) Present state of the art in hydroforming using tubes as blanks
18
Achievable branched tube heights
하이드로포밍 범위(4) Achievable branched tube heights The achievable height decreases with an increasing degree of difficulty
19
Hydroformed Products
20
Exhaust gas system(1) 2,01-16 V-4-cylinder Heat resistant
stainless steel
21
Exhaust gas system(2) M3 6-cylinder Heat resistant stainless steel
22
VW-Hydroformed subframe
for 4WD drive rear axle
23
Light truck side rail
24
Engine cradle Modified low carbon steel St 34 Pre tube 2,600*65*2 mm
for Opel Astra and Zafira
25
Production lines installed since 1997
26
Hydroformed R&D-front-end
27
Frame-type hydroforming press
하이드로포밍 설비(1) Frame-type hydroforming press
28
Compacting presses/IHV-presses
하이드로포밍 설비(2) Compacting presses/IHV-presses
29
IHV-plant for large-scale series production
하이드로포밍 설비(3) IHV-plant for large-scale series production
30
IHV-press/IHV-control/Robots
하이드로포밍 설비(4) IHV-press/IHV-control/Robots
31
하이드로포밍 설비(5) Press plant 2*50,000 kN
32
Press plant for the production of Cu T-fittings
하이드로포밍 설비(6) Press plant for the production of Cu T-fittings
Similar presentations