Hydroforming 하이드로포밍의 적용 유형 : 튜브 vs. 판재 튜브 벤딩 금형 구조 하이드로포밍 제품 프레스 설비 및 생산라인
하이드로포밍의 적용(1) Drive shaft Inlet cone BMW rear axle
하이드로포밍의 적용(2)
Tube vs. Sheet Hydroforming
Production line for tube hydroforming
Tube bending(1)
Tube bending(2)
Tube bending(3)
하이드로포밍의 해석(1)
하이드로포밍의 해석(2)
하이드로포밍의 해석(3)
Schematic view of a die layout 금형 구조(1) Schematic view of a die layout
Die systems for prototyping and production 금형 구조(2) Die systems for prototyping and production
금형 구조(3) Hole punching, notching and bending during hydroforming
Internal pressure as a function of the inside radius 하이드로포밍 범위(1) Internal pressure as a function of the inside radius
Hydroforming parts for the fitting industry 하이드로포밍 범위(2) Hydroforming parts for the fitting industry
Present state of the art in hydroforming using tubes as blanks 하이드로포밍 범위(3) Present state of the art in hydroforming using tubes as blanks
Achievable branched tube heights 하이드로포밍 범위(4) Achievable branched tube heights The achievable height decreases with an increasing degree of difficulty
Hydroformed Products
Exhaust gas system(1) 2,01-16 V-4-cylinder Heat resistant stainless steel
Exhaust gas system(2) M3 6-cylinder Heat resistant stainless steel
VW-Hydroformed subframe for 4WD drive rear axle
Light truck side rail
Engine cradle Modified low carbon steel St 34 Pre tube 2,600*65*2 mm for Opel Astra and Zafira
Production lines installed since 1997
Hydroformed R&D-front-end
Frame-type hydroforming press 하이드로포밍 설비(1) Frame-type hydroforming press
Compacting presses/IHV-presses 하이드로포밍 설비(2) Compacting presses/IHV-presses
IHV-plant for large-scale series production 하이드로포밍 설비(3) IHV-plant for large-scale series production
IHV-press/IHV-control/Robots 하이드로포밍 설비(4) IHV-press/IHV-control/Robots
하이드로포밍 설비(5) Press plant 2*50,000 kN
Press plant for the production of Cu T-fittings 하이드로포밍 설비(6) Press plant for the production of Cu T-fittings